PSA PIN388D/PIN388L User Manual - Manual (Page 14)

PINKERTON User Manual
12
PINKERTON Operation
Keypad Key Functions
After a code is entered or the

key is
pressed, you have 10 seconds to select the
operation you wish to perform. During this
time all 8 Zone lights will flash to indicate
that a key should be pressed. If no key is
pressed within 10 seconds, the keypad will
revert to idle mode. Enter your code to start
again.
The key is always used as the "clear key" to abort the current operation.
Operation of all keys
PANIC
Key

Enter a User Code followed by

or enter
 
to trigger the Panic
function. The Panic function can trigger the siren or strobe light or dialler
as programmed by your installer.
DURESS
Key

Enter a User Code followed by

or enter
 
to trigger the Duress
function. The Duress function can trigger the siren or strobe light or dialler
as programmed by your installer.
TEST
Key

Enter a User Code followed by

or enter
 
to trigger the Test
function. The Test function is used to test the dialler by sending a test
transmission to the programmed telephone numbers. This function is only
available if your system is programmed to report alarms to a monitoring
station.