PSA PIN388D/PIN388L User Manual - Manual (Page 7)

PINKERTON Quick Setup
5
Commissioning the Dialler Panel
Austel Requirements:
Austel requirement’s state that all Dialler Panels connected to the Telephone Network must have
the Telephone connection and termination work performed and completed by a current Austel
Licence Holder.
To Assign for Local Dialling (to a nominated telephone number) for Self
Monitoring Purposes.
Step 1: On Keypad
Enter:

Clears the Keypad
Followed by:

Enter programming mode:
You are now in Programming Mode (ON-LINE light will flash).
Step 2: On Keypad
To set up Personal Reporting format:
Enter:

(Address number)
Followed by:

(Exits the programming mode)
Step 3: On Keypad
Re-enter programming mode:
Enter:
Enter:

Step 4: On Keypad
Entering of required telephone number/s.
1 st Telephone Enter:
 
2 nd Telephone Enter:

Note:
(a) The above numbers are examples only. You must enter the correct numbers to dial
according to the Home owner’s requirements. A maximum of two telephone numbers
can be programmed.
(b) The phone numbers can consist of a mix of mobile phones numbers and local phone
numbers. Only one phone number can be programmed if required.
(c)

is used to finish the phone number.
(d) completes address (allows next address).
Step 5: On Keypad
Exit
programming:
Enter: