PSA PIN388D/PIN388L User Manual - Manual (Page 18)

PINKERTON User Manual
16
ISOLATE
Key

This operation allows Zones 1 - 8 to be manually isolated or re-enabled at
any time and is only available to holders of user codes 0 to 7. The ON-
LINE, LOW BATT, AC FAIL and ON lights will illuminate and the Zone
lights will show the current manual isolate status of the Zones.
A Zone light being ON, means that Zone is manually isolated.
As keys

to

are pressed, the relevant Zone light will toggle on or
off. When the light is on the Zone is isolated.
The key is used to exit out of isolate mode (isolate mode will also end
if there are no keys pressed for 10 seconds).
Note that isolated Zones only remain isolated until the next time the alarm
system is turned OFF, even if the alarm is already OFF. AC fail, Low
battery, Panic, Test and Duress inputs cannot be isolated.
See page 13 for examples.
PROGRAM
Key

Enter the key follow by installer or master code followed by

to
enter programming mode. Only available to the master code and the
installer code.
ON (HOME MODE)
Key

Enter the key follow by any user code followed by

or enter
 
to turn the alarm system ON in Home Mode. ON light will flash to indicate
alarm is armed in home mode. Only Zones which are programmed as Home
Zones will be active.