PSA PIN388D/PIN388L User Manual - Manual (Page 24)

PINKERTON User Manual
22
How to turn the system OFF
The ON light will be on or flashing.
1. Enter ....................To clear the keypad

2. Enter
BBBB
....Your User Code
(All Zone lights will flash - waiting for a command)
3. Enter

....................Turns OFF the system
4. Check that the ON light turns off.
Dialler Model:
If there is a 24 Hour alarm or panic alarm, and the system is On-line, you will
be required to arm then disarm the system. Before entering your code always
enter the key.
Isolating Zones
You are able to isolate (disable) selected Zones and turn the system ON. This
is useful in cases where, for example, a pet will be kept in a certain room or if
a detector has become faulty and must be isolated from the system.
1. Enter ....................To clear the keypad
2. Enter
BBBB
....Your User Code
(All Zone lights will flash - waiting for a command)
3. Enter

....................The ON-LINE, LOW BAT, AC FAIL & ON
lights will turn on to indicate isolation mode.
4.
B
.............................Enter the Zone number/s you wish to
isolate. The corresponding lights will turn on. Pressing the Zone
number again will turn off the isolation for that Zone.
5. Enter ....................To exit isolation mode
The system can now be turned ON as normal. Isolated Zones are
enabled again the next time you turn the alarm OFF.