King Kooker Cast Cooker - Manual (Page 17)

17
8) For storage purposes a locking bracket and bolt are provided with double and triple burner units.
After the cooker has completely cooled, remove the windguard shield (if applicable) and legs. Lay the
cooker upside down on a flat surface. Wrench tighten locking bolt into the nut on center support. Fold
windguard, if provided with your unit, and place it long side up across the center of the cooker with the
locking bolt through the center hole. Place the legs on top of the windguard (if provided) alternating
each foot in opposite directions. Place the locking bracket across the four legs and over the locking bolt.
Screw the lock washer and nut over the locking bolt. Tighten to hold securely in place.
9) Go to the use and care section of this manual for further instructions.
bAFFle PlAte Assembly
If your package includes a baffle plate(s), please follow the below directions for use (models CS14B,
CS29B, CS42B and CS8TWB only).
a. The purpose of the baffle plate(s) is to spread the flame across the bottom of the pot. The baffle
plate(s) must be installed before lighting your cooker. NEVER install a baffle plate(s) once a
burner has been lit.
b. Locate the side of the baffle plate(s) which has the four 3/8” (.97 cm) spacers. This is the
bottom of the baffle plate(s). See below picture.
c. Place the baffle plate(s) with the spacers pointing down onto the top prongs of the cooker frame
directly over the burner(s). The baffle plate(s) should sit flush on top of the prongs with the
spacers resting against the side of the prongs. See below picture. Always make sure that the
baffle plate(s) are properly installed and stable before placing a cooking utensil on them or
lighting cooker.
d. Go to the use and care section of this manual for further instructions.
Baffle Plate
Bottom
Spacer
Top
Prong
Baffle Plate