King Kooker Cast Cooker - Manual (Page 18)

18
1803PKP Work table Assembly Instructions
Cooker
Frame
Work Table
1) Place edge of work table into U-clip receivers
on cooker frame to attach the work table
assembly to the cooker. See Picture.
2) Go to the use and care Section of this
manual for further information.
cs01 Assembly Instructions
reQuIred tools: Adjustable Wrench
CS01 Parts List:
(1)Top Frame
(1)Casting/Air Shutter
(1)LP Hose/Regulator
(1)Thermometer
(4)Leg
(1)Bottom Shelf
(2)Side Work Shelf
(2)Support Bracket wtih U Clips
1) Review the contents in your package. Make sure all listed components for your model are included.
2) Go to pg. 9 for casting installation instructions.
3) Install the four legs into the top frame by matching the numbers on the legs to the numbers on the leg receivers (for
example: 1 to 1, 2 to 2, etc...) Snap in leg bolts through receiving holes on frame. Make sure the leg bolts pop
completely out and legs are locked in position.
4) Install bottom shelf into shelf clips on legs.
5) Hang side work shelves onto top frame using the U clips welded to frame. Attach support brackets to side work
shelves and bottom shelf as per diagram by fitting the U clip of one end of support bracket to bottom of side shelf
and the other end to the side of bottom shelf as pictured above.
6) Refer to Figure 1 pg. 10 for hose assembly instructions. Then go to the use and care Section of this manual for
further instructions.
Fry bAsKet HAndle Assembly
Required Tools: Adjustable Wrench and Screwdriver
1. Attach handle by inserting bolts (round head to inside of pan) into holes indicated in
black. Apply nuts and tighten.
2. Some models of baskets have a 4 bolt “square” design for assembly. Attach handle
by inserting bolts through supplied holes on basket and handle (round head of bolt
to inside of pan.) Apply nuts and tighten.
* Model May Vary
From Picture
Insert bolts in marks as instructed