Outdoor cooker assembly, Tools required – King Kooker Cast Cooker User Manual

Page 9

Advertising

tools reQuIred:

torQue WrencH or AdjustAble WrencH, leAK testInG solutIon

1. Before assembling, check that all cooker components are included in the shipping carton.

Identify these cooker parts from the assembly drawing. Accessories such as pots may vary

according to model. Check the list of accessories on your cooker box. The following parts are

considered essential and should be included in your package regardless of model number.

required Parts lists:

cooker stand, cast burner(s), lP Hose and regulator, thermometer(s)

If any of the above parts are missing, contact Metal Fusion, Inc. at 1-800-783-3885 between the

hours of 7:30 a.m. and 3:30 p.m. CST Monday through Friday for replacements.

2. Read assembly instructions, and understand sequence of assembly, before commencing to

assemble your cooker.

3. If your casting(s) is not pre-installed follow the below cAstInG InstAllAtIon directions.

sectIon I

outdoor cooKer Assembly

tHe use And cAre mAnuAl must be reAd And understood

beFore usInG tHe APPlIAnce

Throughout this manual the words appliance, cooker, fryer/boiler, burner and stove will be

used interchangeably to refer to the King Kooker

Outdoor Cooker.

A) Remove top nut from casting bolt. Leave bottom nut attached and tightened (if applicable.)

B) Place the casting bolt through the hole on the flat bar casting support bracket as pictured

below. The venturi tube of the burner should be located underneath the windshroud. For

cookers supplied with a heat plate, place the heat plate onto the casting bolt beneath the

flat bar casting support bracket.

C) Reinstall nut to casting bolt. Tighten. Check to see if casting is pointing straight up and is

sturdy.

bottom nut (If Applicable)

top nut

casting bolt

Front VIeW

sIde VIeW

Venturi tube

Heat Plate

(If Applicable)

casting

bolt

shroud

Flat bar

casting support

bracket