Ransburg Evolver NE A11279-XX, A11281-XX, A11775-XX, A11776-XX User Manual
Page 28
23
Evolver NE Solventborne Robotic Atomizers - Maintenance
>
The fluid tip [34] should always be installed
and tightened before installing the needle
and valve springs.
NOTE
>
After tightening the fluid tip, always check
to see if the proper gap of 1/16" (1.59mm)
between the needle nuts and air valve stem
occur, before installing the needle and valve
springs back into the head.
!
C A U T I O N
NOTES
10. Screw fluid tip [34] back into place. Hand tighten
first, then with a small wrench, tighten an additional
30
°.
11. Replace air cap locator [33], air cap [35], and air
cap retainer [36].
12. Apply a thin film of petroleum jelly to valve and
needle springs [2] and [3]. Install the springs back
into the end cap and the spray head assembly.
13. Screw end cap [1] back on.
The spray head can be removed from assembly as
shown in Figure 5 for cleaning and service.
AA-05-01.5