Ransburg Evolver NE A11279-XX, A11281-XX, A11775-XX, A11776-XX User Manual
Page 33
28
Evolver NE Solventborne Robotic Atomizers - Maintenance
8. Reassemble the remaining parts as shown in
Figure 6 making sure that the alignment tab on the
bushing [14] lines up with the align groove in the
body [19].
9. Torque the seal carriage [13] to 35-40 lbs•in (4.0-
4.5 Nm).
10. If the u-cup needs to be replaced, assemble
on piston plate [9] and push both onto shaft, tighten
securely with piston nut [7] and install in body as
one assembly.
11. Assemble the remainder of the applicator head
as stated earlier.
12. If the locking tab plug connection [24] needs
to be replaced, remove socket head screw [22] and
connection plug [24] from body.
13.
Reinstall the connection plug [24] into the
body, making sure the tabs on the bottom align
with the notches in the body [19].
14. Insert and tighten the screw [22], making sure
the tabs remain inside the notches [24] in the
body.
NOTES
AA-05-01.5