Battery operation, Battery eliminator – SKC 210-2000 AirChek 2000 User Manual
Page 10
7
Battery Operation
2. Carefully align the batt ery jack on
the replacement batt ery pack with
the batt ery terminal on the bott om
of the pump base plate and push
the batt ery pack into place.
3. Replace and tighten the two
security screws removed in
Step 1.
Use of a repaired or rebuilt battery pack voids any warranty and the UL
Listing for intrinsic safety.
Do not charge or operate the pump from the charger in hazardous
locations!
Use only an SKC-approved charger and battery pack designed for the
AirChek 2000 Sample Pump to ensure reliable performance. Failure to do
so voids any warranty and the UL Listing for intrinsic safety.
Use of any device other than the approved battery pack to power the
pump voids the UL Listing for intrinsic safety and any warranty.
Failure to follow warnings and cautions voids any warranty.
Battery Eliminator
The Batt ery Eliminator is an accessory that converts alternating current (AC)
to direct current (DC) from which the pump can be operated for extended
runs. The Batt ery Eliminator should be used in non-hazardous locations
only. See page 30 for ordering.
To use the Batt ery Eliminator, the batt ery pack must be removed from the
pump (see Replacing the Batt ery Pack on page 6). The Batt ery Eliminator is
comprised of two pieces, (1) a wall cube that converts AC voltage to DC
voltage and (2) a power adapter that reduces DC voltage. The wall cube
fi ts into a standard wall outlet and its plug end is inserted into the power
adapter. The power adapter is fi tt ed on the pump in place of the batt ery
pack.
Use the battery eliminator to operate the pump in non-hazardous
locations only.
Use of the battery eliminator to power the pump voids the UL Listing
for intrinsic safety.
For more information on battery care and maintenance, go to
Batt ery
terminal
Pump base
plate
Batt ery
jack
Batt ery
pack