SKC Limited Pocket Pump MTX - Manual (Page 16)

Page 14 210-PMTXM Issue F www.skcltd.com
Getting Started
The LCD screen will briefly show the pump serial number, the internal software version number and then the
elapsed run time at 0 min.
8) Switching Between Constant Flow and Constant Pressure Modes
The Pocket Pump is shipped set up in Constant Flow mode. To switch from Constant Flow mode to Constant
Pressure mode and vice versa the following sequence is required:
With the pump running, press [ ] to switch to HOLD mode, press , and then .
9) Switching Between Standard and Enhanced Display Modes
The Pocket Pump is shipped set up in Standard Display mode. In order to view all of the available run-time data
the pump must be switched to Enhanced Display mode, using the following sequence:
With the pump running, press [ ] to switch to HOLD mode, press , and then .
To revert to Standard Display mode from Extended Display mode the following sequence is required:
With the pump running, press [ ] to switch to HOLD mode, press , and then .
10) Changing the Temperature Display Units
To change the temperature display units from °C to °F and vice versa, ensure that the pump is in Enhanced
Display mode and enter the following sequence:
With the pump running, press [ ] to switch to HOLD mode, press , and then [ ].
11) Changing the Back Pressure Display Units
To change the temperature display units from inches of water to millimetres of mercury and vice versa, ensure
that the pump is in Enhanced Display mode and enter the following sequence:
With the pump running, press [ ] to switch to HOLD mode, press , and then [ ].