SKC Limited Pocket Pump MTX - Manual (Page 6)

Page 4 210-PMTXM Issue F www.skcltd.com
Specifications
Pump Features
Battery charging options
SKC offer two battery charger options for the Pocket Pump MTX series pumps, a single
charger (Part No. 223-229A) and a five station charger (Part No. 223-107A). When the
battery pack is fitted into the pump, a fast charge mode is enabled providing a charge
time of up to 6 hours. If the battery is charged external to the pump then the charge time
will be up to 16 hours.
Mains power option
The 223-229A single charger model can also be used as a mains adaptor to run the
pump for indefinite periods whilst connected to the electrical mains supply. Note that it is
recommended to ensure that the battery is fully charged prior to commencing sampling.
Warning - The pump must not be used in potentially explosive areas when the
charger is connected.
Keypad cover
The pump controls are situated beneath a sliding cover to prevent accidental actuation of
the keypad during a sample run.
LCD screen LCD screen indicates run-time data, operating and fault modes and battery charge state.
Constant flow mode Provides compensated constant flow control for single tube sampling applications.
Constant pressure mode Provides constant pressure control for multiple tube sampling applications.
Sample hold function Enables pausing and restarting of the pump during a sample.
Low battery shutdown
Automatic pump shutdown in the event of a low battery condition. The low battery shutoff
voltage is selected to prevent over-discharge of the battery which can cause degradation
of the battery performance. The pump retains the run-time data in the event of a low
battery shutdown.