4 connecting to a pc – Hochiki FIRElink-100 User Manual
Page 31
FIRElink-100 – Installation Manual
Page 31 of 40
© 2010 Hochiki Europe (UK) Ltd
9-5-0-345/ISS4/OCT10
NOTE: The detector address on the SenseNET loop and the Fire Panel addressable protocol address are
the same, in other words, no address translation is performed. Some protocols may not support
all the available alarm levels and fault reporting is usually a general fault with no detailed fault
information. Please consult the specific FIRElink-APIC protocol documentation for more
information.
4.4 Connecting to a PC
To connect a single stand-alone detector to a PC, connect the PC‘s serial port directly to the detector‘s 9-
way RS232 port, which is situated on the bottom surface of the detector case. Connections for this cable
are shown below: