Chapter 1 introduction, 1 attention marks, 2 safety precautions – IDEC SE4D Type 4 Hand User Manual

Page 5

Advertising
background image

4

CHAPTER 1 INTRODUCTION

1-1 Attention Marks

This instruction manual employs the following attention marks

,

depending on the

degree of the danger to call operator’s attention to each particular action. Read the following

explanation of these marks thoroughly and observe these notices without fail.

Besides, the attention mark is prepared for the helpful information, detail instruction related to each

part, and reference item or page.

If you ignore the advice with this mark, death or serious injury could result.

If you ignore the advice with this mark, injury or material damage could result.

Remarks

The supplementary content is described with this mark.

REFERENCE

The related content is described with this mark.

1-2 Safety Precautions

■ Use this device as per its specifications. Do not modify this device since its functions and

capabilities may not be maintained and it may malfunction.

■ This device has been developed / produced for industrial use only.

■ Before using this device, check whether the device performs properly with the functions and

capabilities as per the design specifications.

■ In case of disposal, dispose this device as industrial waste.

User in charge

● The user in charge has responsible to indicate the person to take the training required for the

safety system, using method, installation, operation, and maintenance.

● This device is used and managed by the specialist, never use this device by other operator.

Specialist

● A person who is appropriately educated, has widespread knowledge and experience, and

can solve various problems which may arise during work.

Operator

● The operator should read this instruction manual thoroughly, understand its contents, and perform

operations following the procedures described in this manual, for the correct operation of this device.

● In case this device does not perform properly, the operator should report this to the person in

charge and stop the machine operation immediately. The machine must not be operated until

correct performance of this device has been confirmed.

Advertising