Teledyne LeCroy HFP1000 - Manual (Page 17)

Operator’s Manual
922251-00 Rev A 11
Clips, continued
C LIP (0.8 MM )
A pincher like tip designed to hold onto larger wires and
components than possible with the Micro Clip, including through-
hole mounted components.
This clip cannot be connected directly into either of the probe
head sockets; it must be connected to a lead.
PK006-4, package of 2.
G ROUND S PRING WITH H OOK
A flexible spring connected to a square pin that fits into either of
the probe head sockets. Designed to be used as a ground lead,
there is a hook on the end of the spring so that it can probe
general circuits.
The Ground Spring with Hook is an optional accessory for the
HFP1000.
PACC-LD001, package of 4.
S QUARE P IN G ROUND S PRING
A flexible spring connected to a square pin that fits into either of
the probe sockets. Designed to be attached to a square pin on the
circuit under test.
PACC-LD002, package of 4.