Teledyne LeCroy Kibra DDR User Manual
Page 45
Kibra DDR Protocol Analyzer User Manual
43
Recording Options Setup
Teledyne LeCroy
Figure 2.12: DDR4 Recording Options Dialog: Basic Settings Tab
Click on the SPD (Serial Presence Detect) icon
to view the SPD information as
shown above to display the SPD information window (see
). This
feature is available on interposers which support SPD capture. Only the Kibra 380 DDR3
UDIMM does NOT support SPD reading.
Once acquired, this SPD info will be saved in the Trace File for viewing later in the Trace
Info view. In addition, if you click the Apply SPD
button, the values in the SPD will
be applied to the memory controller settings wherever possible.
IMPORTANT! These values reflect only the DIMM's abilities, and might not correspond to the
capabilities of the current Memory Controller on the Host. It is up to the user to verify
that the values used in the Memory Controller settings are correct for the setup under
test.
Click on this icon to display the SPD information
Click on this button to apply the appropriate SPD
values to the current Memory Controller Settings