Teledyne LeCroy Kibra DDR - Manual (Page 65)

Kibra DDR Protocol Analyzer User Manual 63
Recording Options Setup Teledyne LeCroy
Sequence Trigger
Sequence triggers can be set to be performed on signals. The options are:
 Arm on
 Signals ‐ Click the link to open the DDR Select Signals dialog (see Figure 2.34
on page 65 .)
 No Arm
 Trigger on
 Signals ‐ Click the link to open the DDR Select Signals dialog (see Figure 2.34
on page 65 .)
 Trigger After ‐ specified (nck)
 Reset Arm
 Never
 Signals ‐ Click the link to open the DDR Select Signals dialog (see Figure 2.34
on page 65 .)
 After ‐ specified (nck)
Figure 2.32: Sequence Trigger Settings
Note: Hold mouse over fields to display tooltips.
The Sequence Trigger feature provides a powerful triggering engine which allows for
defining the trigger at the signal level with arm and roll‐back condition. You can define
the following trigger conditions:
 Trigger on any signal transition
 Trigger on combination of signals that make a specific command
 Trigger on sequence of conditions
 Some custom violation detection sequences
The advance trigger has three major conditions:
 Arm condition: This condition is used to define condition before trigger.
 Reset‐Arm condition: This condition causes resetting of the Arm condition.