Teledyne LeCroy IBTracer 4X - Users Manual Ver.2.20 User Manual
Page 34
Advertising
26
IBTracer 4X Protocol Analyzer User’s Manual
CATC
SW Version 2.2
It is not necessary to restart the Bus & Protocol Analyzer Analyzer. The Bus
& Protocol Analyzer Analyzer takes approximately 25 seconds to
reinitialize. During this time the UPAS Status LED is on, indicating that
power-on diagnostics are being run. If there is a hardware failure, the
Trigger LED will blink after initialization is complete. If this occurs, contact
CATC for customer support.
Advertising
This manual is related to the following products: