2 setting up the petracer edge card, 2 setting up the pe tracer edge card – Teledyne LeCroy PETracer PCI Express Edge User Manual User Manual
Page 23
PETracer Edge User Manual
Chapter 3: Installation
Teledyne LeCroy
15
3.2 Setting Up the PETracer Edge Card
Step 1 Remove the card from its shipping container.
Step 2 Connect the USB cable between the USB port on the card and a USB
port on the host machine.
Step 3 Connect the external 12-volt power supply to the Analyzer unit.
Step 4 Connect the external 12-volt power supply to a 100-volt to 240-volt,
50 Hz to 60 Hz, 60 W power outlet. This turns on the Analyzer, which has
no power switch.
Step 5 Follow on-screen Plug-and-Play instructions for the automatic
installation of the Analyzer as a USB device on the host machine (the
required USB files are included on the installation CD). Step through the
Windows
®
hardware wizard. If the wizard prompts you for driver
information, point it to the CD which should be in your disk drive.
The host operating system detects the Analyzer and begins to install the USB
driver.