Teledyne LeCroy STX M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 121)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 119
Exercise and Capture LeCroy Corporation
PHY Setting Dialog
Sierra M6‐4 and Sierra M6‐2 only: The PHY Setting & Change Speed command supports
1.5, 3, and 6 Gbps speed changing. You can run commands for different speeds, which is
especially useful for device checking. The Analyzer should support the Auto‐Speed mode.
Click the ... button to display the PHY Setting dialog.
Figure 2.99: SAS: PHY Setting Dialog
Select Speed Negotion Window 1 (1.5 Gbps) or 2 (3 Gbps).
For SNW‐3 PHY Capabilities, you can select Calculate PARITY bit or not.
For Line 0, enter Start, TX SSC Type, and/or Requested Logical Link Rate.
For Line 1, enter G1 without SSC, G1 wirth SSC, G2 without SSC, G2 with SSC, G3 without
SSC, and G3 with SSC.