Teledyne LeCroy STX M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 128)

LeCroy Corporation Exercise and Capture
126 Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual
2. Click the Find device button to display all active addresses.
Figure 2.118: SAS: Active SAS Addresses
3. To assign commands to an active address, right‐click an address and choose:
Insert To Cursor assigns all commands up to the cursor to the chosen address.
Insert: To All assigns all commands to the chosen address.
Record and Play
This feature allows the selection of a range of commands in a trace and exports them to a
previously saved *.sac file for execution by the SAS Initiator Emulator or *.stc file for
execution by the SATA Host Emulator. You can export commands from all available
samples, between X and Y cursors, or between designated commands.
To perform this action:
1. Run a capture project or open a previously run and saved a captured trace file.
2. Set X and Y cursors to export between cursors.