Vanguard TTRA-S2 (ATRT-03 S2, ATRT-03A S2, ATRT-03B S2, Tri-Phase) - Manual (Page 11)

REV 2 TTRA-S2 VERSION 1.x SOFTWARE MANUAL
8
3.2 System Configuration
Before using the program, the system configuration parameters should be reviewed and
changed as required. To configure the program settings:
1. Make sure the TTRA-S2 software is running on the PC.
2. Click on the System-Config menu. The following window will be displayed:
a. Communications
If the ATRT is connected to the PC via the USB interface, make sure that the “USB
Enable” checkbox is checked.
If the ATRT is connected to the PC via the RS-232C interface, make sure to un-check
the “USB Enable” checkbox, and then select the correct RS-232C COM: port from the
“Port:” drop-down list.
b. Misc
Make sure the “Save Setup File” checkbox is checked if you would like to
permanently save the configuration settings. If this box is not checked, any settings
you change will only stay active for the current session and will be reset the next
time you run the software.
Type the number of tests that need to be run in the “Test Limit” input box. The test
limit defines the number of tests to be used in the transformer test plan. For
example, if the transformer has 10 tap positions, the test limit should be set to 10.
c. Test Plan Path
The default location where test plans are stored on the PC hard drive is listed in the
“Test Plan Path” section. You can change the default storage location by clicking on
the “Browse” button and then selecting a different folder.