Vanguard VCBA ver.10.xx - Manual (Page 34)

REV 2 VCBA VERSION 10.xx SOFTWARE MANUAL
32
If you do not want to display the velocity curve on the graphic test results:
1. From the File menu click on System Config and then click on System Setup… The
following window will be displayed:
If the “Plot Velocity Curve” checkbox is already checked, click on the checkbox to un-
check it. Click on the “Save” button, and then click on the “OK” button. If you do not
click on the “Save” button, any settings you change will only stay active for the current
session and will be reset the next time you run the software.
2. Click on the Graph/Results menu and the graphic test results will be displayed without
the velocity curve as shown below: