Vanguard CT-6500 S2 - Manual (Page 29)

CT-6500 Series 2 Operating Instructions
28
9.1.1 Timing an OPEN Operation (With No Insertion Resistors)
The following example shows the steps for performing an Open Test on a circuit breaker.
Table 3.0 Open Operation With No Insertion Resistors
STEP OPERATION ACTION DISPLAY
1 READY TIMER FOR BREAKER OPERATION.. PRESS #1 KEY. INSERTION RESISTOR?
1.NO
2.YES
2 SELECT NO INSERTION RESISTOR. PRESS #1 KEY. TIMING WINDOWS:
1.WINDOW = 1 SEC
2.WINDOW = 10 SEC
3. WINDOW = 20 SEC
3 SELECT 1-SECOND TIMING WINDOW. PRESS #1 KEY. TRIGGER MODE:
1. INTERNAL TRIGGER
2. EXTERNAL TRIGGER
4 SELECT INTERNAL TRIGGER. PRESS #1 KEY. TIMING MODE:
1. OPEN 2. CLOSE
3. O-C 4. C-O
5. O-C-O
5 SELECT OPEN OPERATION. PRESS #1 KEY. OPEN TIMING
Hold "ARM" Switch,
Then "START".
"STOP" to ABORT
6 INITIATE OPEN COMMAND. HOLD THE "ARM"
SWITCH AND
PRESS THE "START"
KEY.
TEST IN PROGRESS
Hold "ARM" Until
Test complete.
(Up to 25 seconds)
7 OBSERVE BREAKER OPERATED.
ANALYZER IS READY TO OUTPUT RESULTS.
NONE. 1.RUN TEST 06/12/07
2.GET RSLT 19:20:01
3.SET-UP
4.DIAGNOSTIC
Go to section 9.2 to print a test report.
NOTE
One-second timing windows are used for breaker timing. The 10 and 20 second
timing windows are used for long timing events (i.e. timing circuit-switchers).
The user can set the CT-6500 to print tabulated and graphical reports
automatically after it completes a test. See Paragraph 9.17 for the automatic print
setting.