Vanguard CT-6500 S2 - Manual (Page 59)

CT-6500 Series 2 Operating Instructions
58
9.15 Check Cable Hookup
The following steps allow the user to check the CT-6500 contact cable connections to the
circuit breaker.
Table 20.0 Checking the Cable Hookup
STEP OPERATION ACTION DISPLAY
1 SELECT DIAGNOSTIC. PRESS # 4 KEY. 1. SLOW-CLOSE TEST
2. CHECK HOOKUP
3. TEST TRANSDUCER
4. NEXT PAGE
2 SELECT CHECK HOOK UP. PRESS # 2 KEY. MAKE SURE BREAKER
IS IN CLOSE POSITION,
THEN PRESS "START"
3 INITIATE TEST. PRESS THE "START"
KEY.
1 2 3
C - - -
“START” to RETEST
“STOP” to EXIT
4 RETURN TO MAIN MENU. PRESS THE "STOP"
KEY.
1.RUN TEST 06/10/07
2.GET RESULTS 20:10:01
3.SETUP
4.DIAGNOSTIC
NOTES
1. The CT-6500 will also print a test report with the thermal printer.
2. A contact closure is shown as "C" on the LCD and printout.
3. An open contact is shown as "-" on the LCD and printout.