Extron Electronics VSC 500_700_700D User Guide - Manual (Page 31)

Command Description ASCII Command Response Additional Description
Firmware Version, Part Number and Information Requests
Query firmware version
number Q/q x.xx ] Display firmware version
Request part number for VSC
500 N/n 60-476-01 ] Display part # for VSC 500
Request part number for VSC
700 N/n 60-477-01 ] Display part # for VSC 700
Request part number for VSC
700D N/n 60-477-02 ] Display part # for VSC 700D
Request information I/i Hrt X!
• Vrt X!] Display status of VSC
Command and Response Table for SIS Commands: VSC 700/700D Only
Command Description ASCII Command Response Additional Description
Horizontal Filter (detail)
Specify the horizontal filter
value X1! D Dhz X1!] Specify the detail value
Decrement one step -D Dhz X1!] Decrease the detail level by one
step
Increment one step +D Dhz X1!] Increase the detail level by one step
View the horizontal filter value D X1!] Show the horizontal detail level
Flicker Filter
Specify the flicker filter value X1! d Dvz X1!] Specify the flicker value
Decrement one step -d Dvz X1!] Decrease the flicker by one step
Increment one step +d Dvz X1!] Increase the flicker by one step
View the flicker filter value d X1!] Show the flicker value
Command and Response Table for Special Function SIS Commands:
VSC 700/700D Only
The syntax for setting a special function is X\ *_ # where _ is the function number and
X\ is the value. To view a function’s setting, use _# where _ is the function number. In
the following table the values of the X\ variable are different for each command/function.
These values are given in the rightmost column.
Command Description ASCII Command Response Additional Description
Encoder Filter (sharpness)
Specify the encoder filter level
Example: X\ * 10#
3 * 10#
Enc X\]
Enc 03 ]
Specify the encoder filter level (0 - 3)
Example: set the encoder filter level to 3
View the encoder filter level 10# X\] Show the encoder filter level
VSC 500/700/700D User Guide • Serial Communication 25