Extron Electronics VSC 500_700_700D User Guide - Manual (Page 35)

Uploading the firmware from the PC to the VSC
Connect the PC to the VSC 500, 700, or 700D via the RS-232 port of the scan converter.
Start the control program (see the “
Using the Control Program ” section). Next, select
Update Firmware from the Control Program window and follow the instructions.
Figure 29. Update Firmware
Select Upload Firmware File from the following window. The uploading of the firmware
to the VSC 500, 700, or 700D will take a few minutes.
Figure 30. Upload Firmware File
NOTE: The original factory-installed firmware is permanently available on the VSC 500,
700, or 700D. If the attempted upload of new firmware fails for any reason, the
VSC will automatically revert to the factory-installed firmware.
VSC 500/700/700D User Guide • Serial Communication 29