Extron Electronics VSC 500_700_700D User Guide - Manual (Page 32)

Command and Response Table for Special Function SIS commands:
VSC 500/700/700D
Command Description ASCII Command Response Additional Description
Output Video Type
Set the output video type X\ *6# Tpo X\] Specify the output video type:
0 = RGBHV (default)
1 = RGBS
2 = RGsB
3 = YUV
Example 1* 6# Tpo 1 ] Example: specify output video as RGBS
View the output video type 6# X\] View the output video type
Video Standard
Set the video standard X\ *14# Rte X\] Select the output standard:
0 = NTSC (default)
1 = PAL
Example: 1*14# Rte ] Example: set output rate as PAL
View the video standard 14# X\ ] View the output standard
No Input Test Pattern
Set the output pattern when
no input signal X\ *13# Out X\] Specify the output pattern when no input
0 = Black screen (default)
1 = Color bars
Example: 1*13# Out 1 ] Example: specify color bars as the output
when there is no input signal
View the output pattern when
no input signal 13# X\] View the output pattern when no input
Auto Imaging
Set the VSC to auto image 55# Img ] Automatically center and size the image
to fill the display screen.
Control Software for Windows
The included control software for Windows offers another way to control the VSC via
RS-232 connection in addition to the Simple Instruction Set commands. The graphical
interface of the control program includes the same functions as those on the front panel of
the VSC and some additional features that are only available through the Windows-based
software
The minimum requirements for the PC:
• Windows ® XP, Service Pack 2, Windows 7 or later
• Intel ® Pentium ® II processor with a 400 MHz clock speed or faster
• At least 64 MB of RAM Device
• At least 10 MB of Hard Disk space
Installing the Program
1. Insert the DVD into the drive. The installation program should start automatically.
The Extron software DVD window appears.
VSC 500/700/700D User Guide • Serial Communication 26