Agilent Technologies USB/GPIB Interface Converter 82357A - Manual (Page 25)

Chapter 1 25
Installing the 82357A
Step 4: Configuring the 82357A
5 Run Connection Expert. Click the blue IO icon in the taskbar notification
area and click Agilent Connection Expert. Wait for the Connection Expert
window to appear.
6 Edit Default Settings. Click on the USB/GPIB icon in the explorer view
at the center of the Connection Expert window. In the property pane
on the right, click
Change Properties... to change the properties for the
82357A.
7 In the Agilent 82357 Interface Converter properties dialog box, set the
VISA interface ID (also called the VISA Interface Name) , the SICL interface
ID (also called the SICL Interface Name) , the Logical Unit and GPIB
address values as required. Then, click the OK button to apply the
new settings.
8 Only the Green READY LED Should Remain ON. After you click OK , the
properties dialog box disappears and only the green READY LED
should remain ON to indicate the 82357A has been configured. The
USB/GPIB icon and property pane in Connection Expert should show
a green check mark, indicating the Verified state.
NOTE
Connecting Multiple 82357As. An Agilent 82357A USB/GPIB Interface
Detected dialog box should appear each time you plug an 82357A into
a USB port. For example, if you plug three 82357As into USB ports, three
dialog boxes should appear, one for each 82357A. Each dialog box will
remain until you remove it by clicking
OK (or the x box) . These dialog
boxes will only appear if Connection Expert is not running.