1 unpacking, Npacking – IEI Integration POC-17i_19i-Series_IEI User Manual
Page 24
POC-17i/19i Series
Page 12
WARNING:
The labels on the external box are best to be read at a distance of
30 cm due to the small label size.
2.1 Unpacking
To unpack the flat panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the flat panel PC has been
properly installed. This ensures the screen is protected during the
installation process.
Step 1:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
Step 2:
Open the external (second) box.
Step 3:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
Step 4:
Lift the monitor out of the boxes.
Step 5:
Remove both polystyrene ends, one from each side.
Step 6:
Pull the plastic cover off the flat panel PC.
Step 7:
Make sure all the components listed in the packing list are present.