IEI Integration RPC-6022G - Manual (Page 45)

RPC-6022GW Rackmount LCD Workstation
Page 45
Step 2:
Step 1:
Step 2:
Step 3:
Step 4:
Remove the drive slot blank plate from the drive bracket. Step 0:
4.5.5 Install Drives
The drive bracket supports one 5.25” and three 3.5” disk drives. To install disk drives,
follow the instructions below.
Remove the drive bracket from the RPC-6022GW Rackmount LCD Workstation
(see Section 4.5.3).
Remove the appropriate drive slot blank plate (see Section 4.5.4).
Slide the disk drive into the drive bracket. Make sure the signal connectors and
the power connector of the drive are facing the rear of the bracket.
Insert the appropriate number of retention screws into each side of the disk drive
through the drive bracket (Figure 4-8). Step 0:
(Top) (Bottom)
Figure 4-8: 5.25” Disk Drive Retention Screws