IEI Integration RPC-6022G - Manual (Page 66)

RPC-6022GW Rackmount LCD Workstation
Page 66
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Step 8:
Step 9:
Step 10:
Step 11:
Step 12:
5.3 PCI/ISA Expansion Card Replacement
To replace a PCI/ISA expansion card, please follow the instructions below.
Turn off and disconnect the workstation from all power sources.
Remove the workstation from the rack in which it is installed.
Open the top cover of the RPC-6022GW Rackmount LCD Workstation. (See
Section 4.5.1)
Disconnect all internal and external peripheral device connections from the
PCI/ISA expansion card.
Remove the CPU card clamp. (See Section 4.5.2)
Remove the retention screw that secures the CPU card to the slot on the rear
panel.
Slide the expansion card out of the workstation.
Install a new expansion card. (See Section 4.5.9)
Insert the slot retention screw that was removed earlier.
Reinstall the CPU card clamp.
Reinstall the top cover of the workstation. (See Section 4.5.12)
Reinstall the workstation into the rack. Refer to Section 4.6 for complete
mounting instructions. Step 0: