Proface GP4100 - 3.4 Compact HMIs" - Manual (Page 50)

Chapter 4 Installation and Wiring
4-5
„Installing the GP
(1) Insert the GP into the panel cut, as shown.
*1 GP units with Rev.1 or higher have projections. More information about revisions, please read "About
Revision" ( page 13 ).
(2) Insert the installation fastener hooks to the
insertion slots on the GP unit.
(3) Tighten the installation fasteners with a
screwdriver. There are two insertion slots
on both the top and bottom of the GP unit.
• GP unit has two projections
*1
on the top to prevent falling
during installation. Please
insert the GP unit into the
panel at an angle to avoid
hitting the projections.
Insert GP at
an angle.
projections
(2)
Insert the hooks to the
insertion slots.
(3)
Tighten the screw
with a screwdriver