Proface APL3000B - Node Box PC - Manual (Page 61)

PS-3650A/PS-3651A Series Hardware Manual
3-16
„ PS-3651A Series
(1) Turn OFF the power switch of the PS-A unit and remove the power cable. Place the PS-A unit on a flat,
level surface facing the display face downwards.
(2) Unscrew the DISK cover's screws (3) and remove the disk cover.
(3) Mount the HDD unit vertically on the circuit board and plug the HDD unit cable connector in the Serial
ATA interface.
(4) Attach the HDD unit with the screws (4) which are contained in your package. The torque required to
tighten these screws is 0.5 to 0.6 N•m.
(5) Reversing the steps above, return the disk cover to the PS-A unit. The torque required to tighten these
screws is 0.5 to 0.6 N•m.
• Be sure to mount the HDD unit slowly and vertically and not to hit the circuit board
with the HDD unit. Contact may cause a malfunction or damage the HDD unit and
PS-A unit.
Serial ATA Interface