Yokogawa PR300 Power and Energy Meter - Manual (Page 31)

3-10 IM 77C01E01-01E
For the PR300 with pulse output function only
3.6 Setting Pulse Output Conditions
This section explains how to set pulse output conditions by taking as an example the case when the ON
pulse width is changed from the initial value to 100 ms.
Operation Operation
3
6
7
5
8
ON Pulse Width Setting
screen
ON Pulse Width screen
To return to the Pulse Output Menu
screen, press .
Current value
VT Ratio screen
2
Pulse Output Menu screen
Measurement
Item for Pulse Output screen
4
ON Pulse Width Setting
screen
ON Pulse Width Setting screen
Measured Value screen
1
The parameter (VT ratio)
appears.
Press once.
Press once.
The parameter
(measurement item for pulse
output) appears.
Pulse Unit screen
The parameter
(pulse unit) appears.
The screen changes to the one
for setting the parameter
and the alterable digit blinks.
ON Pulse Width screen
The parameter
(ON pulse width) appears.
Press once.
Setpoint
Hold down for at
least 3 seconds.
Press once.
Using or ,
change the setpoint.
Using or ,
show .
To return to the Measured Value
screen, hold down .
If you do not operate any key for more
than 5 minutes on the Parameter
screen, the PR300 automatically
returns to the Measured Value screen.
To move to the digit to be changed,
use the following keys:
To the left To the right
To re-set the parameter:
Press any key other than
while all digits of the
setpoint are blinking.
The PR300 returns to the initial
setting screen.
9
Press once to
blink the setpoint.
Press once while
the setpoint is blinking.
The setpoint is confirmed and the PR300
returns to the ON Pulse Width screen.
ON pulse width setting completed.