Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 117)

e4/29(VL13), 00:03:12/0, Flags: MJ
e5/2(VL1004), 00:03:12/0, Flags: MJ
L2 (HW) 1:
e5/2, 00:00:07/0, Flags: MJ
L2 MASK: ethe 5/2
Src-Vlan: 1001
Syntax: show ip pim [vrf vrf-name ] mcache [source-address | group-address | counts | dense | dit-
idx dit-idx | g_entries | receiver | sg_entries | sparse | ssm]
The vrf option allows you to display the PIM multicast cache for the VRF instance identified by the vrf-
name variable.
The source-address parameter selects the multicast cache source address.
The group-address parameter selects the multicast cache group address.
The counts keyword indicates the count of entries.
The dense keyword displays only the PIM Dense Mode entries.
The dit-idx variable allows you to display all entries that match a specified dit.
The g_entries keyword displays only the (*, G) entries.
The receiver keyword allows you to display all entries that egress a specified interface.
The sg_entries keyword displays only the (S, G) entries.
The sparse keyword displays only the PIM Sparse Mode entries.
The ssm keyword displays only the SSM entries.
The following table describes the output from this command.
Output fields from the show ip pim mcache command TABLE 12
Field Description
Total entries in mcache Shows the total number of PIM mcache entries
MJ Membership Join
MI Membership Include
ME Membership Exclude - Legend for the mcache entry printed once per page, it gives the
explanation of each of the flags used in the entry.
BR Blocked RPT
BA Blocked Assert
BF Blocked Filter
BI Blocked IIF
Uptime Shows the entry uptime
Rate Shows the Rate at which packets are ingressing for this entry
IPv4 Multicast Protocols
FastIron Ethernet Switch IP Multicast Configuration Guide 115
53-1003085-02