Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 95)

Output fields from the show ip pim mcache command (Continued) TABLE 1
Field Description
AgeSltMsk Shows the slot number on which active module expects ingress traffic. This value is 1 if
the entry is programmed in hardware and is 0 if the entry is not programmed in hardware.
L2 FID Hardware Resource allocated for the traffic switched to receivers in the ingress VLAN.
DIT Hardware Resource allocated for router receivers.
RegPkt Shows the number of packets forwarded due to the Register decapsulation. This field is
displayed only on the active module. This field displays only those entries for which the
device is the RP. However, for a PIM DM entry the RegPkt field is not displayed for the
(S,G) entries on the active module.
AvgRate Shows the average rate of packets ingressing for this entry over a 30 second period. This
field is displayed only on the active module for all entries that are hardware programmed
(the fwd_fast flag is set on the active module).
Profile Shows the Profile ID associated with the Stream.
Number of matching
entries Shows the total number of mcache entries matching a particular multicast filter specified.
Outgoing interfaces
Section This section consists of three parts. L3 OIFs, L2OIFs and Blocked OIFs. And each section
has Format of L3/L2/Blocked followed by (HW/SW) followed by count of the number of OIF
in each section.
Additionally, each section displays the OIFs one per line. And shows the OIF in the format
eth/Tr(Vlan) followed by uptime/expiry time, followed by the Flags associated with each
OIF.
L3 Shows whether the traffic is routed out of the interface.
L2 Shows whether the traffic is switched out of the interface.
HW Shows whether the entry is hardware forwarded.
SW Shows whether the entry is software forwarded.
Eth/Tr(VL1) Shows the outgoing interface on the specified VLAN.
IPv4 Multicast Protocols
FastIron Ethernet Switch IP Multicast Configuration Guide 93
53-1003085-02