Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 215)

Configures a metric for comparing the route to other static routes in the static route table
that have the same destination. The range is 1-16; the default is 1.
distance distance-value
Configures the route's administrative distance. The range is 1-255; the default is 1.
name name
Name for this static route.
Modes VRF configuration mode
Usage Guidelines The no form of this command deletes a previously configured next-hop static multicast route.
Examples This example adds a route to network 10.1.1.0/24 with next hop 10.2.1.1.
Device(config-vrf)# ip mroute 10.1.1.0 255.255.255.0 10.2.1.1
History
Release version Command history
8.0.10a This command was introduced.
ip mroute next-hop-enable-default
Enables the option to use the default mroute to resolve a static mroute next hop.
Syntax ip mroute [ vrf vrf-name ] next-hop-enable-default
no ip mroute [ vrf vrf-name ] next-hop-enable-default
Command Default Static mroutes are not resolved using the default mroute.
Parameters vrf vrf-name
Configures a static mroute for this virtual routing and forwarding (VRF) route.
Modes VRF configuration mode
Usage Guidelines The no form of this command disables the default mroute option for next hops.
Examples This example enables the use of the default mroute to resolve a static mroute next hop:
Device(config-vrf)# ip mroute next-hop-enable-default
History
Release version Command history
8.0.10a This command was introduced.
ip mroute next-hop-enable-default
FastIron Ethernet Switch IP Multicast Configuration Guide 213
53-1003085-02