Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 223)

Specifies a VRF route.
static
Specifies a static multicast route.
connected
Specifies a directly attached (connected) multicast route.
ip-subnet [ mask ]
Specifies an IP address.
Modes Privileged EXEC mode
Examples This example displays information for IP multicast routes:
Device(config)# show ip mroute
Total number of IP routes: 5
Type Codes - B:BGP D:Connected S:Static; Cost - Dist/Metric
Destination Gateway Port Cost
Type Uptime
1 20.20.20.0/24 220.220.220.1 ve 220 1/1
S 8m54s
2 50.50.50.0/24 DIRECT ve 50 0/0
D 8h26m
3 77.1.1.1/32 DIRECT loopback 1 0/0
D 8h26m
4 129.129.129.0/24 DIRECT ve 129 0/0
D 8h26m
5 220.220.220.0/24 DIRECT ve 220 0/0
D 2h49m
This example displays information for static multicast routes:
Device(config)# show ip mroute static
Type Codes - B:BGP D:Connected S:Static; Cost - Dist/Metric
Destination Gateway Port Cost Type Uptime
1 20.20.20.0/24 220.220.220.1 ve 220 1/1 S 8m54s
This example displays information for directly attached multicast routes:
Device(config)# show ip mroute connected
Type Codes - B:BGP D:Connected S:Static; Cost - Dist/Metric
Destination Gateway Port Cost Type Uptime
1 50.50.50.0/24 DIRECT ve 50 0/0 D 8h26m
2 77.1.1.1/32 DIRECT loopback 1 0/0 D 8h26m
3 129.129.129.0/24 DIRECT ve 129 0/0 D 8h26m
4 220.220.220.0/24 DIRECT ve 220 0/0 D 2h49m
This example displays information for IP multicast route 50.50.50.100:
Device(config)# show ip mroute 50.50.50.100
Type Codes - B:BGP D:Connected S:Static; Cost - Dist/Metric
Destination Gateway Port Cost Type Uptime
1 50.50.50.0/24 DIRECT ve 50 0/0 D 8h26m
History
Release version Command history
8.0.10a This command was introduced.
IP Multicast Commands
FastIron Ethernet Switch IP Multicast Configuration Guide 221
53-1003085-02