Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 157)

Enter ve and its number , or ethernet and its port-address to display information for a specific virtual
routing interface, or ethernet interface.
The tunnelnum parameter specifies a GRE tunnel interface that is being configured. The GRE tunnel
interface is enabled under the router PIM configuration.
Entering an address for group-address displays information for a specified group on the specified
interface.
The report shows the following information:
Output of show ip igmp interface TABLE 23
This field Displays
Intf The virtual interface on which IGMP is enabled.
Port The physical port on which IGMP is enabled.
Groups The number of groups that this interface or port has membership.
Version
Oper The IGMP version that is operating on the interface.
Cfg The IGMP version that is configured for this interface.
Querier Where the Querier resides:
The IP address of the router where the querier is located
or
Self - if the querier is on the same router as the intf or port.
Max response
oQrr Other Querier present timer.
GenQ General Query timer
V1Rtr Whether IGMPv1 is present on the intf or port.
V2Rtr Whether IGMPv2 is present on the intf or port.
Tracking Fast tracking status:
Enabled
or
Disabled
IPv4 Multicast Protocols
FastIron Ethernet Switch IP Multicast Configuration Guide 155
53-1003085-02