Brocade Fabric OS Encryption Administrator’s Guide Supporting RSA Data Protection Manager (DPM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 275)

Fabric OS Encryption Administrator’s Guide (DPM) 255
53-1002922-01
Encryption group merge and split use cases
6
• After the failback completes, the cryptocfg
--
show
-
hacluster
-
all command no longer
reports active failover.
SecurityAdmin:switch> cryptocfg --show -hacluster -all
Encryption Group Name: brocade_1
Number of HA Clusters: 1
HA cluster name: HAC3 - 2 EE entries
Status: Committed
WWN Slot Number Status
EE1 => 10:00:00:05:1e:53:89:dd 0 Online
EE2 => 10:00:00:05:1e:53:fc:8a 0 Online
Encryption group merge and split use cases
This section describes the following recovery scenarios and related operations:
• “A member node failed and is replaced” on page 255
• “A member node reboots and comes back up” on page 256
• “A member node lost connection to the group leader” on page 257
• “A member node lost connection to all other nodes in the encryption group” on page 257
• “Several member nodes split off from an encryption group” on page 258
• “Adjusting heartbeat signaling values” on page 259
• “EG split possibilities requiring manual recovery” on page 260
A member node failed and is replaced
Assume N1, N2 and N3 form an encryption group and N2 is the group leader node. N3 and N1 are
part of an HA cluster. Assume that N3 failed and you want to replace the failed N3 node with an
alternate node N4.
Impact
When N3 failed, all devices hosted on the encryption engines of this node failed over to the peer
encryption engines in N1, and N1 now performs all of the failed node’s encryption services. Rekey
sessions owned by the failed encryption engine are failed over to N1.
Recovery
1. Deregister the node N3 from the group leader node.
SecurityAdmin:switch> cryptocfg –-dereg –membernode <N3 switchWWN>
2. Reclaim the WWN base of the failed Brocade Encryption Switch.
SecurityAdmin:switch> cryptocfg --reclaim WWN –membernode <N3 switchWWN>
3. Synchronize the crypto configurations across all member nodes.
SecurityAdmin:switch> cryptocfg –-commit