Brocade Fabric OS Encryption Administrator’s Guide Supporting RSA Data Protection Manager (DPM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 75)

Fabric OS Encryption Administrator’s Guide (DPM) 55
53-1002922-01
Configuring encryption storage targets
2
Configuring encryption storage targets
Adding an encryption target maps storage devices and hosts to virtual targets and virtual initiators
within the encryption switch. The storage encryption wizard enables you to configure encryption for
a storage device (target).
NOTE
It is recommended that you configure the host and target in the same zone before configuring them
for encryption. If the host and target are not already in the same zone, you can still configure them
for encryption, but you will need to configure them in the same zone before you can commit the
changes. If you attempt to close the Encryption Targets dialog box without committing the changes,
you are reminded of uncommitted changes in Brocade Network Advisor.
The wizard steps are as follows:
1. Select Encryption Engine
2. Select Target
3. Select Hosts
4. Name Container
5. Confirmation
6. Configuration Status
7. Important Instructions
Adding an encryption target
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 6 on page 14.)
2. Select a group, switch, or engine from the Encryption Center Devices table to which to add the
target, then select Group/Switch/Engine > Targets from the menu task bar.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays. (Refer to Figure 38 .)