Brocade Fabric OS Encryption Administrator’s Guide Supporting RSA Data Protection Manager (DPM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 304)

284 Fabric OS Encryption Administrator’s Guide (DPM)
53-1002922-01
FS8-18 blade removal and replacement
6
NOTE
Because the FS8-18 blade was inserted in the same slot as the previous blade, no change of
HA cluster container ownership is required; the HA cluster configuration is retained.
16. If “manual” failback was set on the HA cluster, you must manually fail back the LUNs owned by
the newly replaced EE.
17. Check the EG state using the following command to ensure that the entire EG is in a converged
and In Sync state.
FabricAdmin:switch> cryptocfg –-show –groupcfg
Single-node EG replacement
The following procedure applies to single or multiple FS8-18 blades.
1. Power off the FS8-18 blade. Remove the I/O Link and FC cables from the blade, noting where
each was attached so the replacement blade can be cabled properly.
2. Replace the old FS8-18 blade with the new FS8-18 blade and reconnect the FC cables and I/O
Link cables.
3. Insert the new FS8-18 blade in the same slot of the chassis that was used by the old FS8-18
blade. Reconnect the I/O sync ports to the same private LAN as the I/O sync ports of the old
blade, and confirm that the IP address of the I/O sync ports (Ge0 and Ge1) is same as the
previous IP address.
4. Log in as Admin or FabricAdmin on the replacement node.
5. Zeroize the new encryption engine (EE) using the following command:
FabricAdmin:switch> cryptocfg -–zeroizeEE [slotnumber]
6. If the encryption group (EG) has a system card authentication enabled, you need to reregister
the system card through the BNA client for the new EE. Refer to Chapter 2, Configuring
Encryption Using the Management Application.”
7. Initialize the new EE using the following command:
FabricAdmin:switch> cryptocfg –-initEE [slotnumber]
8. Register the new EE using the following command:
FabricAdmin:switch> cryptocfg –-regEE [slotnumber]
9. Enable the new EE using the following command:
FabricAdmin:switch> cryptocfg –-enableEE [slotnumber]
10. Verify the new FS8-18 blade EE has the same master key as the other EEs in the EG using the
following command:
FabricAdmin:switch> cryptocfg --show –groupmember –all