Brocade Mobility 1240 Access Point Installation Guide - Manual (Page 11)

Brocade Mobility 1240 Access Point Installation Guide 7
53-1002917-01
Chapter
2
Hardware Installation
Installation instructions
A Mobility 1240 Access Point mounts either on a wall (with M4 x 25 pan head
screws and wall anchor - or equivalent) or on a suspended ceiling T-bar.
Once the Mobility 1240 Access Point is installed with facade and cabled, the cables
(Ethernet and module connections) should not be visible when looking directly at
the unit (ceiling and wall mounts).
To prepare for the installation:
1. Match the model number on the purchase order with the model numbers in the
packing list and on the case of the Access Point.
2. Verify the contents of the box include the intended Mobility 1240 Access Point,
and the included hardware matches the package contents on page 4.
3. Review site survey and network analysis reports to determine the location and
mounting position for the Mobility 1240 Access Point.
4. Connect a CAT-5 or better Ethernet cable to a compatible 802.3at or 802.3af
power source and run the cable to the installation site. Ensure there is
sufficient slack on the cable to perform the installation steps.
NOTE
When operating in a Gigabit Ethernet environment, CAT-5e or CAT-6 cable is
recommended for Gigabit operation.
Part Number Description
BR-AP124066040US 802.11n 3x3:3 access point dual radio US version
BR-AP124066040EU 802.11n 3x3:3 access point dual radio European version
BR-AP124066040WW 802.11n 3x3:3 access point dual radio non-US and non-EU (rest of
world) version