Brocade Mobility 1240 Access Point Installation Guide - Manual (Page 59)

Radio Frequency Interference Requirements—FCC
5
Brocade Mobility 1240 Access Point Installation Guide 55
53-1002917-01
Label Marking: The Term "IC:" before the radio certification only signifies that
Industry Canada technical specifications were met
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (EIRP) is not
more than that permitted for successful communication.
The device could automatically discontinue transmission in case of absence of
information to trans-mit, or operational failure. Note that this is not intended to
prohibit transmission of control or signaling information or the use of repetitive
codes where required by the technology.
The maximum antenna gain permitted for devices in the band 5725-5825 MHz
shall comply with the e.i.r.p. limits specified for point-to-point and non point-to-point
operation as appropriate.
In compliance with respective local regulatory law, Brocade AP software provides
professional installers the option to configure the antenna type and antenna gain
for approved antennas.
This radio transmitter (identify the device by certification number, or model number
if Category II) has been approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not included in this list,
having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
Le présent émetteur radio (identifier le dispositif par son numéro de certification ou
son numéro de modèle s'il fait partie du matériel de catégorie I) a été approuvé par
Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous
et ayant un gain admissible maximal et l'impédance requise pour chaque type
d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est
supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de
l'émetteur.
Refer to section 2.8 of this guide for a listing of the 2.4 and 5 GHz antennas initially
approved for use with the Mobility 1240.