Brocade Mobility 1240 Access Point Installation Guide User Manual
Page 22
Suspended Ceiling Tile (Plenum) Mount Instructions
2
18
Brocade Mobility 1240 Access Point Installation Guide
53-1002917-01
9. Fit the light pipe into hole in the tile from its unfinished side.
10. Slide the badge onto the light pipe from the finished side of the ceiling tile.
11. Attach the antennas to their correct connectors. For more information on
supported Mobility 1240 antennas, see
“Mobility 1240 Access Point antenna
NOTE
Brocade recommends attaching safety wire to the access point safety wire tie
point or security cable (if used) to the access point’s lock port.
12. Align the ceiling tile into its former ceiling space.
13. Cable the access point using either power over Ethernet or the approved
Mobility 1240 power supply (PWRS-14000-247R).
For power over Ethernet installations: