Brocade Mobility 1240 Access Point Installation Guide - Manual (Page 21)

Suspended Ceiling Tile (Plenum) Mount Instructions
2
Brocade Mobility 1240 Access Point Installation Guide 17
53-1002917-01
To install the access point above a ceiling:
1. If possible, remove the ceiling tile from its frame and place it, finish side down,
on a work surface.
2. If required, install a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.) in
diameter, in the ceiling space.
3. If required, install and attach a security cable to the access point’s lock port.
4. Mark a point on the finished side of the tile where the light pipe is to be
located.
5. Create a light pipe path hole in the target position on the ceiling tile.
6. Use a drill to make a hole in the tile the approximate size of the access point
LED light pipe.
CAUTION
Brocade recommends care be taken not to damage the finished
surface of the ceiling tile when creating the light pipe hole and
installing the light pipe.
7. Remove the light pipe’s two rubber stoppers (from the access point) before
installing the light pipe.
8. Connect the light pipe to the bottom of the access point. The dual channel light
pipe is mated to the access point by firmly pressing the light pipe into the two
round openings that contained the two rubber plugs removed in the previous
step.