Condec PIN8010 - Manual (Page 26)

20 PIN8000/PIN8010 Operation and Maintenance Manual
Installation:
1. Wrap two turns of 1/2" Teflon tape around threads of the CGA-580 nipple (PN 57150) pressure fitting.
2. Hold the CGA-580 nipple pressure fitting in a vise by flats located on the nipple.
3. Slide the CGA-580 nut (PN 57154) over threads of the CGA-580 nipple pressure fitting.
4. Thread and tighten the adapter fitting (PN 60803) onto the CGA-580 nipple pressure fitting using a 3/4"
wrench.
5. Remove the assembly from the vise and install a cheat seal pad (PN 54854) on the “AN” thread side of
the adapter fitting (PN 60803).
6. Thread into the input hose and tighten using 3/4" and 9/16" wrenches.
4.2.18 AC Fuse (PN 57472), Removal and Installation
1. Disconnect the power cord and line filter. Remove the fuse holder at the AC input.
2. Inspect the fuse. If blown, replace with a 1/2 amp 250 volt, 20mm x 5mm diameter fuse (PN 57472).
3. Replace the fuse holder at the AC input location.
4.2.19 Panel Mounted AC Power/EMI Line Filter (PN 58870), Removal and Installation
Note

See Figure 4-1 on page 5 for wiring diagram.
Tools required:
• Phillips screwdriver
• 1/4" open-end wrench or nutdriver
• A/R soldering iron
• A/R shrink sleeving (PN 60735)
• A/R heat gun
WARNING

Disconnect the power cord from the power source and line filter.
1. Remove the front panel from its enclosure as described in Section 4.2.1 on page 6 and carefully set on a
bench top.
2. Remove the three cable connectors from the line filter terminals.
Note

Some units may not have connectors and will require wire leads to be unsoldered.
3. Loosen and remove the line filter retaining nuts on the rear of panel.
Note

Some units may have screws on the front panel.
4. Remove the AC line filter.
5. To install a new line filter, reverse the order of steps 1 through 4. Connect (or solder) wires to the new
line filter as follows:
Green wire to terminal (E) Ground
White wire to terminal (N) Neutral
Black wire to terminal (P) Line
4.2.20 Power Switch (PN 60307), Removal and Installation
Note

See Figure 4-1 on page 5 for wiring diagram.
Tools required:
• Phillips screwdriver
• Flat screwdriver
• 1/4" open-end wrench or nutdriver
• A/R soldering iron
• A/R shrink sleeving (PN 60735)
• A/R heat gun