Lincoln Electric IM511 RANGER 9 - Manual (Page 17)

Welder Controls - Function and Operation
ENGINE “ON-OFF” Switch
When placed in the “ON” position, this switch
energizes the engine ignition circuit. When placed in
the “OFF” position, the ignition circuit is de-energized
to shut down the engine.
ENGINE “START” Push-Button Switch
Energizes engine starter motor.
“POLARITY” Switch
Three STICK/TIG (constant current) polarity settings:
DC+, DC- and AC
Two wire feed (constant voltage) settings:
DC+ and DC-
NOTE: The setting of this switch must match the
color band setting of the Range Switch (both switches
must be set for the same welding process).
OPERATING INSTRUCTIONS
Additional Safety Precautions
Always operate the welder with the roof and case
sides in place as this provides maximum protection
from moving parts and assures proper cooling air flow.
Read carefully the Safety Precautions page in the
Instruction Manual before operating this machine.
Always follow these and any other safety procedures
included in this manual and in the Engine Instruction
Manual.
Welder Operation
Welder Output
•
Maximum Open Circuit Voltage at 3700 RPM is 80 volts.
•
Duty Cycle: 100% for both welding and auxiliary power.
Constant 250 amps AC @ 25 volts
Current 250 amps DC @ 25 volts
Constant 250 amps DC @ 25 volts
Voltage
RANGER 9
ONAN P218
PERFORMER
KOHLER
CH20S
Low Idle - No Load
2200 RPM
High Idle - No Load
3700 RPM
AC CC Weld Output
250 Amps @ 25 Volts
DC CC Weld Output
250 Amps @ 25 Volts
DC CV Weld Output
250 Amps @ 25 Volts
Auxiliary Power
9000 kVA
.4 gallons/hour
(1.5 liters/hour)
.8 gallons/hour
(3.1 liters/hour)
1.6 gallons/hour
(6.2 liters/hour)
1.8 gallons/hour
(7.0 liters/hour)
1.7 gallons/hour
(6.5 liters/hour)
1.8 gallons/hour
(7.0 liters/hour)
.4 gallons/hour
(1.5 liters/hour)
1.0 gallons/hour
(3.9 liters/hour)
1.5 gallons/hour
(5.7 liters/hour)
1.7 gallons/hour
(6.5 liters/hour)
1.6 gallons/hour
(6.2 liters/hour)
1.7 gallons/hour
(6.5 liters/hour)
Ranger 9 Approximate Fuel Consumption
STICK/TIG (constant current) 6 45,90,120,
range settings 160,200,250
WIRE FEED (constant voltage) 3 LOW,MED,HIGH
range settings
CONTROL” “
Provides a fine welding current adjustment within the
Range Switch settings in the STICK/TIG mode and
welding voltage control with the Range switch set in
the WIRE FEED mode.
-15 -
ON OFF
Explanation of Symbols that Appear on this Equipment
Low Idle High Idle
Never change the “POLARITY” switch setting
while welding. This will damage the switch.
------------------------------------------------------------------------
Never change the “RANGE” switch setting while
welding. This will damage the switch.
------------------------------------------------------------------------
CAUTION
CAUTION
RANGE” Switch “