LT Security PTZIP772X20IR - Manual (Page 44)

User Manual of 5 Inch Network Speed Dome 43
enable the continuous snapshot or event-triggered snapshot in Snapshot
interface. For detailed information, please refer to the Section 6.6.8 Configuring
Snapshot Settings.
6.3.9 Configuring NAT Settings
 UPnP
Universal Plug and Play (UPnP) is a networking architecture that provides
compatibility among networking equipment, software and other hardware devices.
With the UPnP function enabled, you don’t need to configure the port mapping for
each port, and the camera is connected to the Wide Area Network via the router.
Steps:
1. Enter the UPnP settings interface.
Configuration >Advanced Configuration > Network > NAT
2. Check the Enable UPnP checkbox
3. Add a Friendly Name.
Figure 6-23 Configure UPnP Settings
4. Click to save the settings.
 Port Maping
Steps:
1. Check the Enable Port Mapping checkbox
2. Select the Port Mapping Mode as Auto or Manual.
3. If in Manual mode, you can check the checkbox of HTTP, RTSP or SDK port
according to your demand.
4. Click to save the settings.